Installation Photos

Installing clear bra film does take skill but in general, we're simply doing 4 steps over and over again across the front end of the car.

  1. Clean the area where the film will be applied. Make sure you use lint free towels and only install in a wind/dust free environment.
  2. Squirt a nice layer of soapy solution on the area.
  3. Apply film to the area and position the film as needed.
  4. Anchor the film to the vehicle by removing the soapy solution from an area in the middle of the film and squeeze the soapy solution out from under the film little by little out towards the edges of the edges.

For even more in depth instructions, please download this FREE PDF of instructions.